2
Code: 02250151-- 218 SR-- 5 --- S R -- 100
English
2
All figures to which the “see Fig.” references in this text refer can be found at the
end this manual. The language translations for these figures can be found in the
Legend (A3---sized page) inserted after a ll the figures.
1Introduction
1.1 Foreword
The SR dryers are designed to guarantee high quality compressed air and minimum
maintenance.
Please carefully read this manual to obtain maximum performance from your dryer
and ensure its correct installation and start--- up in compliance with manufacturer in-
structions.
1.2 Packaging
The dryer is packaged with a strong cardboard box strapped to a wooden pallet.
Instruction symbols (UNI ISO 780) for the movement, transport and stocking of the
product are printed on two sides of the packing.
FRAGILE: HANDLE
WITH CARE
THIS WAY UP
KEEP DRY DO NOT ROLL STACKING
LIMITATION
USE NO HOOKS
Kg max
1.3 Transport
S Keeptheunitinanuprightposition and do not leave i t outdoors.
S Use a forklift truck to move the machi ne.
S Care should be taken to avoid damaging internal components through poor han-
dling during movement, installation or use.
S Unpack the machine as close as possible to the installation site.
1.4 Storage
If stored the packaged units must be kept inside, protected from humidity, direct
sunlight and rain, and at a temperature within the limits 32---122˚F ( 0 --- 5 0 ˚C).
Moreover, although stacking is permitted the maximum weight must not be more
than the value shown on the packaging.
1.5 Inspection
On receipt of the machine, make sure it has incurred no damage during transit.
If any damage is detected promptly contact the haulage company.
2 Installation
2.1 Dryer installation (see Fig. 1)
a) Dryer should be insta lled indoors; where this i s not possible it must however be
installed in a clean dry area, with a temperature within the limits 41---122˚F
( 5 --- 5 0 ˚C), and sheltered from the effects of di rect weather (including direct sun-
light); do not install the dryer in rooms used for laundry operations.
b) The compressed air inlet temperature must never exceed 140˚F(60˚C). For dif-
ferent temperatures to those indicated above, consult the manufacturer.
c) For most compressed air applicat ions we recommend following the installation
plan (see Fig. 1). Thi s layout ensures optimum compressor, filter and dryer per-
formance and also guarantees excellent air quality whilst minimising operating
costs.
d) Donotobstructthedryerairgrilles.
e) Allow sufficient gap around the unit to facilitate maintenance and ensure unim-
peded air di scharge from the condenser.
To Next Page
Loading...
