Sullair SRC-200 - Safety; Manual Importance and Warnings; Introduction; Handling and Storage

SRC Service Manual
Revision 02
Aug 2007
4. Control System 21
4.1 Power Supply 21
4.2 Controls on the SRC-150 to 200 21
4.3 Controls on the SRC-250 to 1000 22
4.3.1 Inputs 22
4.3.2 Outputs 23
4.3.3 Specifications 23
4.3.4 User Interface 23
4.3.4.1 Lights 24
4.3.4.2 Buttons 25
5. Installation 26
6. Start Up 28
7. Operation & Control (SRC-250 to 1000) 29
7.1 Turning the Dryer On or Off 29
7.2 User Parameter List 30
7.3 Accessing & Modifying User Parameters 31
7.4 Factory Parameter List 32
8. Cycling Operation 33
8.1 SRC-150 to 200 33
8.2 SRC-250 to 1000 33
9. Condensate Drain Operation 35
9.1 SRC-150 to 200 35
9.2 SRC-250 to 325 35
9.3 SRC-400 to 1000 35
9.4 Drain Operating Mode (Parameter D3) 37
9.5 Manual Drain Activation 37
10. Alarms & Warnings 38
10.1 Alarm & Warning List 38
10.2 Troubleshooting Alarms & Warnings 39
10.2.1 HP - High Pressure (Alarm) 39
10.2.2 LP - Low Pressure (Alarm) 40
10.2.3 Ld - Low Dewpoint (Alarm) 41
10.2.4 rSE - Coolant Temperature Sensor Error (Alarm) 42
10.2.5 Hd - High Dewpoint (Warning) 42
10.2.6 drE - Drain Error (Warning) 44
10.2.7 dSE - Dewpoint Sensor Error (Warning) 45
10.2.8 Sr - Service Required (Warning) 45
(Continued on following page…)
Page 2 of 56