HMP-0567E Rev.7 (4/19)
2. Safety Precautions
: DO NOT USE THE PRODUCT IN ANY MANNER NOT DESCRIBED IN THIS MANUAL
OR OUTSIDE THE SPECIFIED LIMITS. FAILURE TO OBSERVE THIS PRECAUTION
COULD CAUSE BREAKDOWN OR DAMAGE TO THE PUMP, RESULTING IN RISK
OF PERSONAL INJURY AND/OR DAMAGE TO PROPERTY.
SUMITOMO PRECISION PRODUCTS ACCEPTS NO LIABILITY FOR USE OF THE
PRODUCT IN ANY MANNER OTHER THAN THAT DESCRIBED IN THIS MANUAL.
1) Precautions for handling the product
: CONFIRM THE MASS OF THE PRODUCT (INDICATED IN THE EXTERNAL
DIMENSIONS DIAGRAM).
IF THE MASS IS 20 KG OR MORE, DO NOT ATTEMPT TO CARRY THE PRODUCT
UNAIDED.
: UNDER NO CIRCUMSTANCES SHOULD YOU APPROACH THE PRODUCT WHILE
TRANSPORTING IT USING HOISTING EQUIPMENT.
2) Precautions for installing/removing the product
: ENSURE THAT INSTALLATION/REMOVAL IS PERFORMED BY A PERSON WITH THE
RELEVANT SPECIALIZED KNOWLEDGE.
: DO NOT GET ON TOP OF, STRIKE OR APPLY EXTERNAL FORCE TO THE PUMP.
FAILURE TO OBSERVE THIS PRECAUTION COULD RESULT IN PERSONAL INJURY
AND/OR DAMAGE TO THE PUMP.
: BEFORE INSTALLATION OR REMOVAL, BE SURE TO POWER OFF THE UNIT.
: CLEAN THE SURFACES ON WHICH THE PUMP AND FLANGES WILL BE
MOUNTED, AND CLEAN THE BOLT HOLES.
: WHEN INSTALLING THE PRODUCT, BE SURE TO USE THE SPECIFIED BOLTS, AND
TIGHTEN THEM TO THE PREDETERMINED TORQUE.
: THE PRODUCT AND HYDRAULIC FLUID MAY BE HOT IMMEDIATELY AFTER
OPERATION. PRIOR TO REMOVAL, FIRST CONFIRM THAT THE PRODUCT AND
HYDRAULIC FLUID ARE AT A SUITABLE TEMPERATURE (30°C to 40°C). NEXT,
RELEASE ANY RESIDUAL PRESSURE IN THE HYDRAULIC PIPING BEFORE
REMOVING THE PUMP.
To Next Page
Loading...