9
3. Models FF642DADA, LDR24A, ADFD243, SCFF532DADA, LDF24A, ADRF244,
SPRF2D24ADA and LDRF24A have the same size as ADRD241.
4. Models FF642D, SCFF532D, SPFF51OS2D and SPRF34D have the same size as
SPR627OS2D.
Anti-tip Bracket Installation
To reduce the risk of tipping the unit by abnormal usage or improper loading, the appliance must be
secured by properly installing the anti-tip device packed with the appliance.
• Place the anti-tip bracket on the floor as shown in the figure. An anti-tip bracket must be installed
at the left side.
• Mark the locations of the 4 holes of the anti-tip bracket on the floor.
• Use a 5/16” masonry drill bit and insert plastic anchors.
• Secure bracket to floor using screws.
• Slide appliance into position and make sure the leg engages the anti-tip bracket.
NOTE: If the unit is relocated, the bracket must be removed and installed in the new location.
Installing the Stainless Steel Handles
This appliance includes two stainless steel handles
that are not required to operate the unit. To install the
handles, follow the instructions below:
1. Remove the door gasket.
2. Install the handle with the screws provided. (DO
NOT over-tighten as this will cause damage to the
stainless steel door surface.)
3. Replace the door gasket.
To Next Page
Loading...
Need help?
General
