Summit FF1512SSIM - 4 Preparation; Things to be Done for Energy; Initial Use

14 /29 EN
Refrgerator / User Manual
4.1. Things to be done
for energy saving
A
Connectng the product to electrc
energy savng systems s rsky as t
may cause damage to the product.
• Do not leave the doors of your
refrgerator open for a long tme.
• Do not put hot food or drnks n your
refrgerator.
• Do not overload the refrgerator,
coolng capacty wll fall when the ar
crculaton nsde s hndered.
• In order to store maxmum amount
of food n the freezer compartment,
the cematc, avalable n the freezer
compartment and easly removable
by hand, should be taken out. Net
volume and energy consumpton
values declared on the power
data plate of your refrgerator are
measured and tested by removng the
cematc. Do not remove the shelves
nsde the freezer compartment and
on the door of freezer compartment.
They should always be used .They
provde ease of use and effcency n
energy consumpton.
• Arflow should not be blocked by
placng foods on the sdes of the
freezer compartment fan. A mnmum
dstance of 3 cm (1.2”) shall be
provded on the sdes of protectve
fan cover.
• The baskets/drawers that are
provded wth the chll compartment
must always be n use for low energy
consumpton and for better storage
condtons.
• Food contact wth the temperature
sensor n the freezer compartment
may ncrease energy consumpton of
the applance. Thus any contact wth
the sensor(s) must be avoded.
• Dependng on the features of your
product, thawng frozen food n
frdge compartment wll both provde
energy savng and preserve the food
qualty.
4 Preparaton
• Do not allow contact of the food wth
the frdge compartment temperature
sensor shown n the fgure above.
4.2. Initial use

ensure that all preparatons are made
n accordance wth the nstructons n
sectons "Instructons for safety and
envronment" and "Installaton".
• Run the product wthout puttng any
food for 6 hours and do not open ts
door unless requred.
C
You wll hear a nose when the
compressor starts up. The lquds
and gases sealed wthn the
refrgeraton system may also
gve rse to nose, even f the
compressor s not runnng and ths
s qute normal.
C
Front edges of the product may
feel warm. Ths s normal. These
areas are desgned to be warm to
avod condensaton.
C
In some models, the nstrument
panel automatcally turns off
5 mnutes after the door has
closed. It wll be reactvated when
the door has opened or any key s
pressed.