Need help?Do you have a question about the Sun Oracle SPARC Enterprise T5120 and is the answer not in the manual?
General| Brand | Sun Oracle |
|---|---|
| Model | SPARC Enterprise T5120 |
| Category | Server |
| Language | English |
Information about basic UNIX commands for system administration tasks.
Defines different shell prompts used in the system.
Lists other available documentation for the servers.
Provides links to web resources for documentation, support, and training.
Instructions on how to provide feedback on the document.
Explains the ILOM service processor's function and independence.
Step-by-step instructions to log in to the ILOM service processor.
Procedure to access the system console via ILOM.
How to reach the OpenBoot 'ok' prompt.
Methods to access the ILOM command prompt.
Instructions for connecting a local graphics monitor for system output.
Steps to power on the server.
Procedures to shut down the server.
How to reset the server.
Instructions for updating the system firmware.
Overview of RAID support and utilities for server disk management.
Steps to create RAID volumes using the on-board controller.
Procedure for hot-plugging mirrored disks into the server.
Procedure for hot-plugging nonmirrored disks into the server.
Table associating internal disk slot numbers with device names.
Instructions for deleting existing RAID volumes.
How to unconfigure a system device using ILOM.
How to reconfigure a system device using ILOM.
Lists and explains device identifiers used by the system.
Maps server devices to the Solaris OS device tree.
Overview of multipathing software for redundant I/O paths.
How to find system faults using ILOM.
How to find system faults using POST diagnostics.
How to use the system locator LED.
Information on configuring automatic recovery from minor faults.
Procedure to clear a fault from the system.
Overview of LDoms software for creating and managing logical domains.
Information on storing and managing Logical Domain configurations.
Describes OpenBoot firmware configuration variables stored on the SCC.
To Next Page
