Sunbeam Domestic 70 User Manual (English)

Questions and Answers:

E
Eric MillerAug 3, 2025
Why does the upper thread keep breaking on my Sunbeam Domestic 70?
- X
  xgouldAug 3, 2025
  The upper thread may break due to several reasons: the machine might not be threaded correctly, so rethread it. The thread tension could be too tight; reduce the thread tension. You might be using a thread that's too thick for the needle, in which case you should select a larger needle. Also, check if the needle is inserted correctly (flat side towards the back) or is damaged and needs replacement. Finally, ensure the thread isn't wound around the spool holder pin; if it is, remove the reel and wind the thread onto it.
V
Vicki UnderwoodAug 12, 2025
What to do if my Sunbeam Domestic 70 Sewing Machine is skipping stitches?
- A
  Alex HintonAug 12, 2025
  If your Sunbeam Sewing Machine is skipping stitches, there are a few potential causes. Ensure the needle is correctly inserted with the flat side towards the back. A damaged needle can also cause skipped stitches, so insert a new needle. The wrong size needle could be the culprit, so choose a needle to suit the thread and fabric. Lastly, check that the foot is correctly attached.
M
Michael SnowAug 25, 2025
How to fix lower thread breaks on a Sunbeam Domestic 70 Sewing Machine?
- M
  Michael FrankAug 25, 2025
  If the lower thread is breaking on your Sunbeam Sewing Machine, it might be due to a few reasons. First, the bobbin case may not be inserted correctly; remove and reinsert it, ensuring the thread pulls easily. Second, the bobbin case may not be correctly threaded; check both the bobbin and bobbin case. Third, the lower thread tension might be too tight; loosen the lower thread tension as described.