Sunbeam DREAMLAND BLD5021 - Troubleshooting; The electric blanket is not heating; The cord or any wiring is damaged; 3 Year Replacement Guarantee

8
Heading
QUICK START
DIGITAL OVEN 22L
User Guide
Need help with your appliance?
Contact our customer service team
or visit our website for information
and tips on getting the most from
your appliance.
Australia | visit www.sunbeam.com.au
phone 1300 881 861
mail Units 5 & 6, 13 Lord Street,
Botany NSW 2019 Australia.
New Zealand | visit www.sunbeam.co.nz
phone 0800 786 232
mail Level 6, Building 5,
Central Park,
660–670 Great South Road,
Greenlane, Auckland.
NEWELL AUSTRALIA PTY LTD. ABN 68 075 071 233
Sunbeam Corporation is a division of GUD Holdings Limited.
Sunbeam is a registered trade mark.
Made in China to Sunbeam’s specification.
Due to minor changes in design or otherwise,
the product you buy may differ slightly from the one shown here.
Approved by the appropriate electrical regulatory authorities.
©Sunbeam Corporation Limited 2020.
05/20
BT7100
Australia
www.sunbeam.com.au
1300 881 861
Suite 1, Level 1,
13 Lord Street,
Botany NSW 2019
Australia
New Zealand
www.sunbeam.co.nz
0800 786 232
Level 6, Building 5,
Central Park,
660-670 Great South Road,
Greenlane, Auckland
New Zealand
Year
3 year
3
Troubleshooting
The electric blanket
is not heating
Check the control is plugged into the electric blanket, and ensure it is clicked
securely into position. If the control connector is not properly fitted to the
blanket, switch the power off at the power outlet, securely attach the control
connector plug to the blanket and then switch the power back on.
Check the power cord is connected to the power outlet and that the power is
switched on.
If you are using a powerboard, check the powerboard is working.
Remember for double, queen and king blankets there are 2 controls. Ensure
both are plugged into the blanket, and both cords are plugged into a power
outlet.
Check the on/off slide switch on the control is switched to ‘on’.
If only one side of the blanket is working, it may simply be because the control
rather than the blanket is not working.
To help resolve your issue quickly, before calling Sunbeam Customer Service,
please check the control. Simply swap the “good controller” to the “faulty” side
of the blanket. Wait 20 minutes to see if the blanket is heating. If it does heat,
the first controller is faulty. If the blanket still does not heat, the blanket may be
faulty. Then call Sunbeam Customer Service line, and they will be able to assist.
The cord or any
wiring is damaged
Do not attempt to repair it yourself. Contact the Sunbeam Customer service line
on 1300 881 861 in Australia or 0800 786 232 in New Zealand.