EasyManua.ls Logo

Sunbeam HE2055 - Troubleshooting Guide; Resetting the safety auto shutoff

Sunbeam HE2055
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
Troubleshooting Guide
If your heater fails to operate check the
following:
Make sure the electrical outlet or circuit
breaker is working.
Check for obstructions. If you find an
obstruction, turn the heater off and follow
the reset instructions in this section.
Check that the thermostat is not set too low.
Turn the thermostat dial to Heating setting
first.
Resetting the safety auto shutoff
Remove any blockage from the front or rear
grille.
Turn the mode selector dial to the Off
position.
Unplug the heater and wait 5-10 minutes for
the heater to cool down.
Once the heater has cooled down, plug the
heater into the power outlet and operate
normally.
1.
2.
3.
4.

Related product manuals