6
ensure that the air intake and outlet are
clear of obstructions.
outlet and turn the power on.
illuminate.
NOTE: When the heater is switched on it
will be automatically set to the Standby
mode.
desired setting, as follows. Each time you
press the mode button it will scroll through
the various settings.
LOW – low heat setting
– high heat setting
– for operating the electronic
thermostat
– for fan only operation
without heat
– the heater remains inactive
when in this mode
NOTE:
the mode is changed from low to high.
button until the standby mode is set and
switch the power off at the power outlet.
Setting the electronic thermostat
the precise temperature. Once the desired
temperature level is reached the heater will
cycle on and off to maintain it.
display the ambient room temperature.
2. Set the desired temperature by turning the
NOTE:
the set temperature the heater will
the room temperature falls below the
preset temperature.
NOTE: It is normal for the heater to cycle
on and off as it maintains the preset
cycling, raise the thermostat setting.
Using your Compact Oscillating
Ceramic Heater
To Next Page
Loading...
