To Next PageTo Next Page
Need help?Do you have a question about the Sunbeam Micro Furnace MF2000 and is the answer not in the manual?
System detects high temperatures and automatically shuts off the heater to prevent overheating, requiring manual reset.
Internal fuse provides additional protection by cutting power during overheat; fuse requires replacement if activated.
Maintains selected temperature by monitoring room conditions and adjusting heat output via an external sensor.
Utilizes 1200 honeycomb holes per disc to heat air, generating up to 40% warmer air than conventional heaters.
Located at the rear of the unit for accurate room temperature measurement, communicating data to the thermostat.
Automatically interrupts power to heating element and fan if the heater is accidentally knocked over.
Amber light indicates AUTO mode; green light indicates MANUAL mode for heater operation.
Illuminates red once the selected temperature level is reached.
Collects dirt and dust from circulating air; removable for easy cleaning.
Selects operating mode: AUTO, MANUAL, or STANDBY.
Thermostatically controlled operation.
Constant heat output from setting 1 to 5.
Displays ambient room temperature and selected setting.
Adjust temperature in AUTO mode or heat setting in MANUAL mode.
Selects operating mode: FAN (cool air), HEAT (heater), or OFF.
Selects desired temperature from 10°C to 27°C; adjusts heat output to maintain it.
Automatically interrupts power to heating element and fan if the heater is accidentally knocked over.
Monitors room temperature and adjusts heat output to maintain selected temperature.
Indicates heater is connected to power outlet and switched on.
Indicates the room has reached the selected temperature.
Collects dirt and dust from circulating air; removable for easy cleaning.
Each disc has 1200 holes heating air up to 40% warmer than conventional heaters.
Remove and rinse filter under warm water; dry completely before replacing.
Store heater in a cool, dry place, preferably in its original carton.
General
