1. All wiring must comply with local and national
electrical codes and must be installed by a
licens ed electrician. Once you have any
ques tions regarding the following instructions,
contact a licensed electrician.
2. C heck available power supply and resolve any
wiring problems B E F OR E installing and operating
this unit.
3. F or your safety and protection, this unit is
grounded through the power cord when
plugged into a matching wall outlet. If you are
not s ure whether your wall outlet is properly
grounded, pleas e cons ult a licens ed
elec tric ian.
4. The wall outlet(3-pin) must match the plug
(3-pin) on the power cord supplied with the unit.
DO NOT use plug adapters or extension cords.
S ee (T able 1) for receptacle and fuse information.
5. The rating plate on the unit contains electrical
and other technical data. The rating plate is located
on the right side of the unit.
If the air conditioner has a serial plate rating
of 115 volts and up to and including 7.5 amps
the unit maybe on a fuse or circuit breaker
with other devices. However, the maximum
amps of all devices on that fuse or circuit
breaker can not exceed the amps of the fuse
of circuit breaker.
If the air conditioner has a serial plate rating
of 115 volts and greater than 7.5 amps it
must have its own fuse or circuit breaker,
and no other device or unit should be
operated on the fuse or circuit breaker.
To avoid the possibility of personal injury,
disconnect the power to the unit before
installing or servicing.
E lectric S hoc k Hazard
E lectrical s pecifications
125
5K 6K 8K
Table 1
15
15
R ATE D VOLTS
C OOLING C AP ACIT Y
AMP S
F US E S IZE
WALL OUT LE T
R E C E P T A CL E AND F US E TY P E S
!
Time Delay Fus e
(or circuit breaker)
P lug type
3
To Next Page
Loading...
