5
Moisture Protection
• To minimize the possibility of rust, avoid placing the refrigerator in a place with heavy
moisture.
• Do not directly spray with water; this will cause poor insulation and current leakage may
occur.
Heat Protection
• The refrigerator should be kept out of direct sunshine and away from any heat sources.
Stable Positioning
• Place refrigerator on a flat and solid surface.
• Do not place refrigerator on soft material such as foam, plastic, etc.
• If the refrigerator is not on a flat surface, adjust the screws appropriately.
• The refrigerator should not be placed in an area with an echo.
Keep Away From Danger
• Do not place the refrigerator near any combustibles such as gas, petrol, alcohol, lacquer,
etc.
• Do not store the above mentioned products in the refrigerator.
Moving the Refrigerator
• When fixed or moved, the refrigerator cannot be set horizontally or declined to more than
45º or upside-down.
Using Your Refrigerator
Temperature Control
• The first time you turn on the refrigerator, set the temperature control to “5” or “low”.
• Let the refrigerator run for 1-2 hours to fully cool before storing food inside.
Notes:
• If the unit is unplugged or the power is lost or turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to reset before waiting, the refrigerator will not
start.
• To conserve energy, put your refrigerator in the coolest place in your room. If the
environment temperature is too high, the temperature in the refrigerator may not get the
target temperature.
To Next Page
Loading...