SHOT OF STEAM”
8
l
The Shot of Steam” provides an extra burst of steam for deep penetration of stubborn wrinkles.
The Shot of
Steamm can be used with dry or steam ironing provided the tank is at least
l/4
full
of water and the temperature dial is set within the steam band.
l
Allow the iron to heat for approximately two minutes.
l
Press the white Shot of Steame button several times to prime the pump.
l
Pump Shot of Steam” button another three to four times in order to clean the unit.
l
The Shot of
Steam@
is now ready for use. The Shot of Steam@’ can be used continuously with
just a short pause between shots. The Shot of Steam’
is
most effective with the
iron
held in
a horizontal position just above the fabric being ironed.
l
If the tank runs dry, unplug the iron and refill with water. The iron may be filled with water
while it is hot. Note: It may be necessary to re-prime the pump before using the
Shot of
Steama again.
SPRAY MIST”
q
(some models only)
l
Use the Spray Mis? to dampen fabrics with stubborn wrinkles
l
Press the gray Spray
Mist@’
button firmly to produce spray.
SAFETY
SMAW
AUTO SHUT-OFF
(some models only)
La
l
When the iron is plugged into 120 volt AC electrical outlet, the steady red light signals the iron
is on or is ready to be turned on.
l If the iron is left on the heel rest unmoved the iron will stop heating in 15 minutes.
The light on the handle will blink to indicate the iron has automatically shut off
and will continue blinking until the iron is restarted or unplugged.
l If the iron is left unmoved in the ironing position or accidentally tipped over, the iron will stop
heating in
30
seconds.
Again, the light on the handle will blink to indicate the iron
has automatically shuf off and will continue blinking until fhe iron is restarted
or unplugged.
l Note: If the temperature dial is turned to the Off position, the light will continue blinking
and then go off.
l
To restart the iron, move the iron back and forth. Allow the iron to heat and continue ironing
as normal.
l
Note:
Although heat is no longer generated once the iron has automatically shut
off
allow sufficient time for the iron to cool before touching the soleplate or storing the iron.
To Next Page
Loading...
