Suncast BMS6202 - Before you Begin...

A Before you Begin...
• Consult your local authorities for any permits required to construct shed.
Prior to the construction of your shed, check with the local building code official to review any required permits or
building limitations.
• A level and sturdy foundation is required before shed construction can begin.
Site preparation information is available later in this manual. A foundation that differs from the specifications within this
manual could prevent proper assembly and may damage parts.
• Read instructions thoroughly prior to assembly.
This kit contains parts that can be damaged if assembled incorrectly or in the wrong sequence.
• Please follow instructions.
Suncast is not responsible for replacing parts lost or damaged due to incorrect assembly.
ib_ •
p ie? Indicates at least 1 additional adult is needed to complete this step.
t
Indicates caution is recommended when using a power drill.
IMPORTANT
IF FOUNDATION IS REQUIRED, COMPLETE SITE PREPARATION AND FOUNDATION CONSTRUCTION BEFORE
UNPACKING ALL PARTS.
OPEN ALL BOXES FIRST AND NEATLY LAYOUT PARTS. SMALL PARTS MAY BE CONTAINED IN EACH BOX. PLEASE
REFERENCE THE PARTS LIST WITHIN THIS MANUAL TO VERIFY ALL PARTS ARE PRESENT.
A Caution
• Power tools can apply excessive torque resulting in damage to the product. If you choose to use a power dril to
assemble the product, Suncast recommends using a variable speed, cordless drill with a variable clutch set at the
lowest setting. A # 2 Phillips driver bit is compatible with the hardware provided. Suncast makes no guarantee that
following this recommendation will prevent damage to the product. Damage to parts due to over- torque are not
covered under Suncast's limited warranty.
• Proper site preparation is required.
• Shed not intended for storage of flammable, caustic or corrosive materials.
• Shed not intended for habitation or for use by children.
• DO NOT stand, sit, or store items on the storage shed roof.
• DO NOT place near objects that are hot or can become hot.
• Heavy articles should not be leaned against the walls, as this may cause panel distortion and permanent damage.
• Suncast is not responsible for damage caused by weather or misuse.
• This kit contains parts with sharp edges. Please be careful when handling, use of work gloves is recommended.
• WHEN DRILLING THROUGH METAL, beware of burrs, shavings and other sharp edges. Safety glasses are
strongly recommended.
• DO NOT place in areas near highly reflective surfaces ( Note: Low- E windows are more reflective than standard
windows and may affect the longevity of the product).
• Product is water resistant and now waterproof. Locate unit away from gutter and down spouts for optimal
performance.
4