Suncast BMS6202 - Care & Maintenance; Assembly Day Tips

A Care & Maintenance
• At regular intervals, inspect your shed to make sure that assembly integrity has been maintained. Repair or
replace broken parts immediately.
• Periodically check that the location you have chosen to set your shed is still level.
• Keep roof clean of snow and leaves.
• To maintain the look of your product, we recommend cleaning it at regular intervals with mild soap and water. DO
NOT use bleach, ammonia, or other caustic cleaners, and DO NOT use stiff bristle brushes. Failure to perform
cleaning at regular intervals could result in permanent staining of the plastic. This type of damage is not covered
under warranty.
A Assembly Day Tips
• DO NOT attempt to assemble on a day with strong winds.
• Set aside appropriate amount of time to completely assemble shed. An incomplete shed assembly may pose a
safety hazard.
• Make sure you have assistance nearby to lift and secure parts in place.
• DO NOT use a torque wrench or hand drill to tighten Easy bolts. Use provided Easy Bolt Driver ONLY.
• Suncast provides extra hardware for small fasteners for customer convenience. In some cases, there will be extra
small fasteners once the assembly is complete.
Note: This product contains parts that are used in different orientations to construct the shed.
Please take note of the orientation of the parts shown throughout this instruction manual. Failure to follow
instructions could result in damage to parts. Suncast is not responsible for replacing parts lost or damaged
due to incorrect assembly.
5