Suncast BMS7480 Series - Page 3

A Before you Begin...
• Consult your local authorities for any permits required to construct shed. Prior to the construction of your
shed, check with the local building code official to review any required permits or building limitations.
• A level and sturdy foundation is required before shed construction can begin. Site preparation information
is available later in this manual. A foundation that differs from the specifications within this manual could prevent proper
assembly and may damage parts.
• Read instructions thoroughly prior to assembly. This kit contains parts that can be damaged if assembled
incorrectly or in the wrong sequence.
• Please follow instructions. Suncast is not responsible for replacing parts lost or damaged due to incorrect assembly.
P
• ...... .. •
BX Indicates at least 1 additional adult is needed to complete this section.
Indicates caution is recommended when using a power drill.
Indicates orientation is critical, refer to illustrations to ensure parts are orientated correctly before assembling.
A Care & Maintenance
• At regular intervals, inspect your shed to make sure that assembly integrity has been maintained. Repair or
replace broken parts immediately.
• Periodically check that the location you have chosen to set your shed is still level.
• Keep roof clean of snow and leaves.
• To maintain the look of your product, we recommend cleaning it at regular intervals with mild soap and water. DO
NOT use bleach, ammonia, or other caustic cleaners, and DO NOT use stiff bristle brushes. Failure to perform
cleaning at regular intervals could result in permanent staining of the plastic. This type of damage is not covered
under warranty.
A Assembly Day Tips
• DO NOT attempt to assemble on a day with strong winds.
• Set aside appropriate amount of time to completely assemble shed. An incomplete shed assembly may pose a
safety hazard.
• Make sure you have assistance nearby to lift and secure parts in place.
• DO NOT use a torque wrench or hand drill to tighten easy bolts. Use provided easy bolt driver ONLY.
• Suncast provides extra hardware for small fasteners for customer convenience. In some cases, there will be extra
small fasteners once the assembly is complete.
Note: This product contains parts that are used in different orientations to construct the shed.
Please take note of the orientation of the parts shown throughout this instruction manual. Failure to follow
instructions could result in damage to parts. Suncast is not responsible for replacing parts lost or damaged
due to incorrect assembly.
3