Suncast BMS7480 Series - Page 4

A Caution
• Power tools can apply excessive torque resulting in damage to the product. If you choose to use a power drill to
assemble the product, Suncast recommends using a variable speed, cordless drill with a variable clutch set at the
lowest setting. A # 2 Phillips driver bit is compatible with the hardware provided. Suncast makes no guarantee that
following this recommendation will prevent damage to the product. Damage to parts due to over- torque are not
covered under Suncast's limited warranty.
• Proper site preparation is required.
• Shed not intended for storage of flammable, caustic or corrosive materials.
• Shed not intended for habitation or for use by children.
• DO NOT stand, sit, or store items on the storage shed roof.
• DO NOT place near objects that are hot or can become hot.
• Heavy articles should not be leaned against the walls, as this may cause panel distortion and permanent damage.
• Suncast is not responsible for damage caused by weather or misuse.
• This kit contains parts with sharp edges. Please be careful when handling, use of work gloves is recommended.
• WHEN DRILLING THROUGH METAL, beware of burrs, shavings and other sharp edges. Safety glasses are
strongly recommended.
• DO NOT place in areas near highly reflective surfaces ( Note: Low- E windows are more reflective than standard
windows and may affect the longevity of the product).
• Product is water resistant and not waterproof. Locate unit away from gutter and down spouts for optimal
performance.
• Maximum weight limit for shelf = 50 lbs. ( evenly distributed).
• To avoid accidental damage to the door latching system, right door handle should remain in the downward
position whenever the door is open.
• To maintain warranty coverage, the product should be padlocked at all times when not in use, refer to the end of
this manual for padlock specifications.
4