Suncast BMS7775 - Page 10

Site Preparation and Platform Construction
(Materials NOT supplied with Shed Kit)
Note: Site preparation is required for this shed. Placing the shed on a constructed foundation is highly recommended.
Without a constructed foundation, settling will probably occur, causing distortion and damage to the shed. Suncast is
not responsible for replacing parts damaged or property lost due to incorrect assembly.
Note: Complete the site preparation and foundation construction before unpacking parts and beginning assembly.
Complete the site preparation and platform construction before unpacking parts.
To prepare your shed site, follow the below steps:
1) Consult your local authorities for building codes and covenants before beginning foundation or erecting
shed.
2) Before any digging, check with local utilities to determine location of buried cables, pipes, etc.
3) Decide which type of foundation you want:
-Concrete slab, 4" thick (Recommended)
or
-Wood platform (Recommended)
Use exterior grade wood. The wood platform should be set on pier blocks or footing. Consult your local
retailer for help to determine the best anchoring method for your particular installation. The provided
plans are sized for the minimum number of cuts to lumber and plywood.
-Without constructed foundation
See how to anchor assembled base to ground on page 11.
4) Prepare the building site:
-The ground should slope away from the foundation area to provide drainage.
-The foundation surface must be flat and level.
—A vapor barrier should be provided to prevent excessive condensation in the shed.
-Follow local building codes for a proper vapor barrier.
5) Anchoring the shed to the foundation:
-Consult your local retailer for help to determine the best anchoring method for your particular installation.
–То secure the shed to a concrete pad, use masonry fasteners available at your local retailer.
-To secure the shed to a wood platform, use 1/4" x 2" long lag screws with washers. See diagram on
page 9 for anchoring locations.
10