Suncast BMS7775 - Page 29

Rotate hinge plates to open position.
Attach one hinge plate to each hinge receptacle on
the inside of right front panel
Secure each hinge with one screw (Y) and one nut
(2).
Repeat for left door (J).
With at least two people, place front header (G)
over the door opening and fit the two protruding
support legs on the left and right front panels into
the pockets molded in the header panel. Secure
the support legs in the pockets using two screws
(AA) in each leg.
Note: DO NOT leave header unsupported until
beam assembly is complete (step 42).
29