Suncast BMS8100 - Page 19

Align tab on bottom of left front corner ( E) with slot on
left floor ( A). Lower panel into slot and lock in place by
sliding panel toward door opening.
7
Note: Use a rubber mallet to " push" left front corner
(E) into locked position.
19
Tip left front corner ( E) back to vertical position and
align lower tabs on right side with slots in floor.
Note: You will hear a snap when tab is fully engaged.
Tip left front corner ( E) outward slightly and bend corner
hinge.
20
Before proceeding, make sure
corner is square ( top view) where it
meets the floor and that panel is flush
(side view) with floor.
If not, repeat Steps 17-19
until square and flush.
1
Top view
0
I
i
Sid iii e,view
0 1.
19