Suncast BMS8100 - Page 20

Align tabs on bottom of side panel ( F) with slots along
floor ( A). Lower panel into slots and lock in place by
sliding panel toward front corner.
7
Note: Use a rubber mallet to " push" side
panel ( F) into locked position.
Secure side panel ( F) with four easy bolts ( NN), working
from floor to roof. DO NOT use torque wrench. Use easy
bolt easy driver ( 00) and hand tighten. Easy bolt head
will be flush when fully seated. DO NOT over tighten
easy bolts.
Note: You may hear a click when easy bolt has been
tightened completely.
20