Suncast BMS8125 - Roof Truss System Assembly

16
Attach side adaptor bracket (FF) at end of left truss
leg (AA) with one cap screw (MM) and one nut (LL).
Repeat for remaining side adaptor bracket (FF).
Note: DO NOT over tighten. This makes roof assembly
difcult.
Roof and Truss Pre-Assembly
Attach two truss cross beams (EE) to two truss legs
(AA) with two cap screws (MM) and two nuts (LL). Stand
truss and check cross beam is level.
Attach truss bracket (CC) to end of one truss leg (AA)
with one hex bolt (RR) and one nut (LL).
Repeat for second truss leg (AA).
Place skylight gasket (YY) into skylight (HH). Place
skylight (HH) onto right roof panel (O). Secure from
underside with eight screws (JJ). Make sure rib on
plastic parts is seated fully against gasket on skylight.
Repeat for remaining roof panels.