Suncast BMS8780T - Assembly - Pre-Assembly and Frame; Pre-Assembly Component Installation

IMPORTANT: If you choose to use a power drill to assemble the product, refer to caution statements for power drill
guidelines. Damage to parts due to over- torque are not covered under Suncast's limited- warranty.
This item uses self- tapping screws in some areas. There are no pre- drilled holes. Some pressure may be needed when
starting to drive the screw. Once the screw pierces the plastic it will drive easier.
Pre- Assembly - Floor Guides
Required Hardware/ Steel Kits
0480377
(S) x12
Stand the right floor ( B) horizontal. From the
bottom of the panel, install 2 door guide
brackets ( R) and secure with 3 screws ( S)
each as shown.
Repeat for left floor ( A).
Barn
Required Hardware/ Steel Kits
(V) x2 (FF) x2
From the inside of the left door ( L) install
2 washers ( V) and 2 screws ( FF).
From the outside of the door place door catch
plate ( W) and 1 door handle ( X) through the
previously installed screws ( FF).
Tighten securely.
(X) x1
13