What to do if my Sundance Spas Aspen is overheating?
If your Sundance Spas Hot Tub is overheating, it means the water temperature has exceeded safe limits. For your safety, do not enter the water. Remove the hot tub cover to help it cool down faster.
Describes risks of hair, limb, body, evisceration, and mechanical entrapment.
Covers grounding, appliance proximity, and GFCI requirements for electrical safety.
Details warnings related to diving, slipping, and chemical handling.
Advises on water chemistry and ventilation to prevent illnesses.
Discusses risks and precautions related to hair and limb entrapment in suction fittings.
Discusses risks and precautions related to torso, buttocks, and jewelry entrapment.
Emphasizes the need for a stable, level base to support the spa's weight.
Guidance on selecting an outdoor location considering shelter, wind, and drainage.
Covers proper foundation, drainage, ventilation, and access for indoor installations.
Outlines voltage, current draw, and circuit breaker requirements.
Steps for preparing the tub and filling it, including cautions.
Steps for turning on power and adding startup chemicals.
How to set the initial sanitizer level for healthy water.
Instructions for setting the desired water temperature.
Details specific features of the Maxxus model hot tub.
Diagram showing how to operate massage and waterfall selectors for Maxxus.
Diagram illustrating the operation of air controls for the Maxxus model.
Diagram showing how to operate massage and waterfall selectors for Aspen.
Diagram illustrating the operation of air controls for the Aspen model.
Diagram showing how to operate massage and waterfall selectors for Optima.
Diagram illustrating the operation of air controls for the Optima model.
Diagram showing how to operate massage and waterfall selectors for Cameo.
Diagram illustrating the operation of air controls for the Cameo model.
Diagram showing how to operate massage and waterfall selectors for Altamar.
Diagram illustrating the operation of air controls for the Altamar model.
Diagram showing how to operate massage and waterfall selectors for Marin.
Diagram illustrating the operation of air controls for the Marin model.
Diagram showing how to operate massage and waterfall selectors for Capri.
Diagram illustrating the operation of air controls for the Capri model.
Covers welcome screen, registration, and Home Menu controls.
Details on operating jets, lights, audio, CLEARRAY, and massage customization.
Details heating modes and programming primary/secondary filter cycles.
How to program reminders for water quality and filter maintenance.
Covers Wi-Fi setup, locking features, time/date, language, and units.
Instructions for cleaning and replacing filter cartridges and monthly cleaning.
Procedure for draining/refilling water and maintaining the spa cover.
Steps to properly prepare the hot tub for winter to prevent freezing damage.
Explains pH importance and methods for sanitizing spa water.
Details CLEARRAY operation, bulb replacement, and quartz tube cleaning.
Guides through diagnosing and resolving common issues and error codes.
Explains various error messages and symbols displayed on the control panel.
Provides typical wiring diagrams for North American 60 Hz models.
Detailed diagrams for Maxxus/Aspen and other specific models.
Configuration settings for dip switches on the control board.
General| Pump(s) | 2 |
|---|---|
| Heater | 4kW |
| Insulation | Full Foam |
| Voltage | 240V |
| Amperage | 50A |
| Shell Material | Acrylic |
| Cabinet Material | Synthetic |
| Dimensions | 84 in x 84 in x 37.5 in (213 cm x 213 cm x 95 cm) |
| Pump Motors | 2.5 HP |
| Filtration | Filtration |
To Next Page