Electronic Dartboard 22/40
EN
Unpacking the Game
Unpack your new dartboard carefully, making sure all parts are included. The following components
are included in this set:
· 1 Electronic Dartboard · Soft tip replacement pack
· 6 Darts (unassembled) · Owner’s Manual
Mounting with adapter
Choose a location to hang the dartboard where is about 10 feet (3.048 m) of open space in front of the
board. The “toe-line” should be 7’9 1/4” (2.37 M) from the face of the dartboard. Since this dartboard is
powered with an AC adapter, you could mount it close to an electronic outlet for convenience. No
matter the dartboard has horizontal or vertical hang hole(s), the center of bullseye should be 5’8” (1.73
m) from the ground. Mark the center location on the wall. Measure the distance between hang hole(s)
and center. Then, make the mark(s) for hang hole(s). Make sure the second mark for hang hole is level
with the first mark. Mount the dartboard on the wall by lining up the hang holes on the back with the
screws. It may be necessary to adjust the screws until the board fits snugly against the wall. If you want
to mount the dartboard even more securely to the wall, you can fasten four screws through the holes
located in the catch ring area (the area outside the scoring segments)
To Next Page
Loading...