Sunforce 5000 Watt POWER INVERTER User Manual (English)

Questions and Answers:

C
Christina FriedmanJul 31, 2025
Why does my Sunforce Inverter have the red LED on?
- A
  Allison JacksonJul 31, 2025
  The red LED on your Sunforce Inverter indicates a few potential issues: the battery voltage might be below 10 volts, the AC appliance's power consumption could be higher than the inverter's specification, the inverter might be overheating, or the inverter itself could be defective. To resolve this, try recharging or replacing the battery. You might also need to use a higher capacity inverter or a lower capacity appliance. If it's overheating, shut off the inverter to allow it to cool, ensuring proper ventilation.
T
tammy88Aug 8, 2025
What to do if my Sunforce 5000 Watt POWER has low or no output voltage?
- K
  Kaitlyn ThompsonAug 8, 2025
  If your Sunforce Inverter has low or no output voltage, it could be due to a low battery voltage, poor electrical contacts causing voltage drop, or using the incorrect type of voltmeter to test the output voltage. Try recharging or replacing the battery, and consider using two batteries for some items. Also, unplug and reattach connections, potentially using shorter or heavier cables. Check the condition of the 12-volt plug and socket, cleaning or replacing them if necessary. Finally, use a true RMS reading meter for testing.
J
jennifer43Aug 15, 2025
Why does my Sunforce 5000 Watt POWER's low battery alarm keep going off?
- J
  Jennifer AndersonAug 15, 2025
  A constant low battery alarm on your Sunforce Inverter typically means the input voltage is below 10 volts or that poor contacts are causing a voltage drop. To fix this, recharge or replace the battery. You might need two batteries to run some devices. Also, unplug and reattach the connections, possibly using shorter or heavier cables. Inspect the 12-volt plug and socket, cleaning or replacing them if needed.
E
Edgar BrownAug 22, 2025
How to stop TV interference from my Sunforce Inverter?
- M
  Monique WilliamsAug 22, 2025
  Electrical interference from the inverter or a weak TV signal can cause TV interference. To minimize this, use a filter in the TV power cord, adjust the placement of the television, or try using a different TV, as different makes and models may respond differently to interference.

Sunforce 5000 Watt POWER INVERTER Specifications

General

Input Voltage	12V DC
Output Voltage	120V AC
Waveform	Modified Sine Wave
Peak Power	10000 Watts
Weight	15.4 lbs (7 kg)
Dimensions	20.87 x 9.06 x 4.13 in (53 x 23 x 10.5 cm)
Efficiency	90%
Power Output	5000 Watts
Protection Features	Short Circuit, Overload, Over Temperature
Cooling	Fan Cooled