Sunforce 11260 - User Manual

Questions and Answers

L
Laura RamirezJul 31, 2025
What to do if the fault LED is on on my Sunforce Inverter?
- M
  Michelle BanksJul 31, 2025
  If the fault LED on your Sunforce Inverter is illuminated, it could be due to several reasons. The battery voltage might be too low (below 10 volts), or the AC appliance you're using might be consuming more power than the inverter can handle. Additionally, the inverter may be overheating due to inadequate ventilation. To resolve this, try recharging or replacing the battery. You might also consider using a higher capacity inverter or a lower capacity appliance. If the inverter is hot, turn it off and allow it to cool, ensuring proper ventilation around it.
H
hsmithAug 7, 2025
How to fix low or no output voltage on Sunforce 11260?
- E
  eric07Aug 7, 2025
  If your Sunforce Inverter is showing a low or no output voltage, it could be due to a few reasons. Firstly, the battery voltage might be low, so try recharging or replacing it; you might even need two batteries for some devices. Secondly, poor connections could be causing a voltage drop; in this case, unplug and reattach all connections, and consider using shorter or heavier cables. Also, check the condition of the 12-volt plug and socket, cleaning or replacing them if necessary. Finally, ensure you're using a true RMS reading meter to test the output voltage.
D
David GarciaAug 15, 2025
Why is the low battery alarm on my Sunforce 11260 always on?
- A
  Alexandra KennedyAug 15, 2025
  If the low battery alarm on your Sunforce Inverter is constantly going off, it's likely due to the input voltage being below 10.5 VDC ± 0.5 VDC, or poor connections causing a voltage drop. To solve this, try recharging or replacing the battery, and consider using additional batteries for your devices if necessary. Also, unplug and reattach all connections, and you may need to use shorter or heavier cables. Inspect the 12-volt plug and socket for any issues, cleaning or replacing them as needed.
D
dawn60Aug 23, 2025
How to stop TV interference from Sunforce Inverter?
- E
  Elizabeth RuizAug 23, 2025
  If your TV is experiencing interference when using the Sunforce Inverter, it could be due to electrical interference from the inverter, or the TV signal might be too weak. You can try using a filter in the TV power cord to reduce the interference. Adjusting the placement of the television can also help. Additionally, try using a different TV, as some makes and models may not experience the same interference.

Summary

Important Safety Precautions

Important Cable Information

About the Circuit Breaker

Full Load AC Output

Features of the Sunforce Products Pro Series Pure Sine Wave Inverter

Getting Started

Calculating Loads (Wattage)

How to calculate continuous load using Amps and AC voltage.

Connecting Your Inverter

Wiring Specifications

Details on AWG wire gauge standards and wire size recommendations.

Connections

Step-by-step guide for connecting inverter power cables and grounding.

Source of Power

While in Use

Remote Control

LCD Display

Trouble Shooting

Specifications

Limited Warranty

Sunforce 11260 Specifications

General

Continuous Power	1000 Watts
Surge Power	2000 Watts
Input Voltage	12V DC
Output Voltage	120V AC
Waveform	Modified Sine Wave
Output Frequency	60 Hz
Efficiency	90%
Cooling	Fan
Weight	7.5 lbs
USB Port	Yes
Protections	Overload, Short Circuit, Over Temperature
Power Output	1000W Continuous
Peak Power Output	2000 Watts