Sunforce Pro Series 11240 User Manual (English)

Other manuals for Sunforce Pro Series 11240

Questions and Answers:

K
Kristina MortonJul 31, 2025
What to do if the fault LED is on on my Sunforce Inverter?
- T
  Teresa ValdezJul 31, 2025
  If the fault LED is on your Sunforce Inverter, it could be due to several reasons. The battery voltage might be below 10 volts, or the AC appliance might be consuming more power than the inverter can handle. It's also possible that the inverter is overheating due to thermal overload. In rare cases, the inverter itself may be defective. To troubleshoot, try recharging or replacing the battery. You might also need to use a higher capacity inverter or a lower capacity appliance. If it's overheating, shut off the inverter to allow it to cool, ensuring proper ventilation. If none of these steps work, you may need to contact a technician.
N
ncooperAug 7, 2025
How to troubleshoot low or no output voltage on a Sunforce Inverter?
- F
  Fernando JenningsAug 7, 2025
  If your Sunforce Inverter has low or no output voltage, the battery voltage may be low, or poor connections may be causing voltage drop. It's also possible you're using the wrong type of voltmeter to test the output voltage. Try recharging or replacing the battery, and consider using two batteries for some items. Check and reattach all connections, using shorter or heavier cables if necessary. Inspect the 12-volt plug and socket for any issues, cleaning or replacing them as needed. Finally, ensure you're using a true RMS reading meter for accurate voltage testing.
T
Tonya SullivanAug 16, 2025
Why is the low battery alarm on all the time on my Sunforce Pro 11240?
- N
  Natasha BrownAug 16, 2025
  If the low battery alarm on your Sunforce Inverter is constantly on, it indicates that the input voltage is below 10.5 VDC ± .5 VDC, or poor connections are causing a voltage drop. To resolve this, try recharging or replacing the battery. You might need additional batteries for certain items. Also, unplug and reattach all connections, potentially using shorter or heavier cables. Inspect the 12-volt plug and socket, cleaning or replacing them if necessary.
M
Michael LawrenceAug 22, 2025
What to do if my Sunforce Inverter is causing TV interference?
- G
  Greg AllenAug 22, 2025
  If you're experiencing TV interference with your Sunforce Inverter, it's likely due to electrical interference from the inverter, or the TV signal might be too weak. You can try using a filter in the TV power cord or adjusting the placement of the television. Sometimes, using a different TV make or model can resolve the issue, as some TVs are more susceptible to interference than others.

Sunforce Pro Series 11240 Specifications

General

Model	11240
Type	Power Inverter
Input Voltage	12V DC
Output Voltage	120V AC
Output Frequency	60 Hz
Output Waveform	Modified Sine Wave
Cooling	Fan
Protection Features	Overload, Short Circuit, Low Voltage
USB Output	No
USB Port	No