SUNGOLD POWER LFPV Series

Questions and Answers

D
Donald DixonAug 13, 2025
How to troubleshoot a SUNGOLD POWER LFPV that won't turn on?
- T
  Todd ClarkAug 13, 2025
  If your SUNGOLD POWER Inverter isn't turning on, the issue could stem from several causes. First, ensure your batteries are properly connected and that all battery-side connections are secure; loose connections or disconnected batteries can prevent the inverter from powering up. Also, check the DC fuse and breaker. Low battery voltage can also be a culprit, so charge the battery to ensure it has sufficient power to start the inverter.
N
Nicholas HoustonAug 17, 2025
What to do if the AC output voltage is low on my SUNGOLD POWER LFPV?
- E
  Erika MorrisAug 17, 2025
  If your SUNGOLD POWER Inverter has a low AC output voltage and turns off loads quickly, the most likely cause is a low battery. Check the condition of your batteries and recharge them if necessary. Ensuring your battery is adequately charged should resolve this issue.
N
nacevedoAug 21, 2025
Why does my SUNGOLD POWER Inverter have no AC output and no indicator lights?
- D
  Debra HodgeAug 21, 2025
  If your SUNGOLD POWER Inverter shows no AC output voltage and the indicator lights are off, it's possible the inverter has been manually switched to the OFF mode. To resolve this, press the switch to either the 'Power saver on' or 'Power saver off' position, depending on your desired setting. This should restore the AC output and indicator lights.
A
Arthur BriggsAug 25, 2025
Why is my SUNGOLD POWER Inverter charger supplying a lower charge rate?
- J
  jfieldsAug 25, 2025
  A lower charge rate on your SUNGOLD POWER Inverter could be due to several reasons. The charger controls might be improperly set, so refer to the section on adjusting the “Charger Rate”. Also, low AC input voltage or loose battery or AC input connections can cause this issue. Ensure you are using qualified AC power and check all DC and AC connections to ensure they are secure.
L
Lisa BoydAug 28, 2025
What causes the SUNGOLD POWER LFPV Inverter charger to turn off when charging from a generator?
- D
  Dr. Michael JacksonAug 28, 2025
  If your SUNGOLD POWER Inverter's charger turns off while charging from a generator, this is likely due to high AC input voltages from the generator. To address this, try loading the generator down with a heavy load or turning down the generator's output voltage. This should stabilize the voltage and allow the charger to function correctly.
R
Randy KellySep 1, 2025
Why do sensitive loads turn off during grid/inverter transfer with my SUNGOLD POWER Inverter?
- C
  Carol AndersonSep 1, 2025
  If sensitive loads are turning off temporarily when your SUNGOLD POWER Inverter transfers between grid and inverting, it may be because the inverter's low voltage trip voltage is set too low for those loads. To fix this, select a narrow AC voltage range using the DIP switch. Alternatively, consider installing a UPS (Uninterruptible Power Supply) to provide a more stable power source during the switch.
W
William ReynoldsSep 5, 2025
What to do if the SUNGOLD POWER LFPV charger is inoperative and won't accept AC?
- A
  Amanda DavisSep 5, 2025
  If the charger on your SUNGOLD POWER Inverter is inoperative and not accepting AC, the AC voltage may have dropped out of tolerance. Check the AC voltage to ensure it is within the proper voltage and frequency ranges. If the voltage is outside the acceptable range, correct the AC input to restore charger function.
C
Cole RossSep 8, 2025
Why is there noise coming from the transformer/case of my SUNGOLD POWER Inverter?
- D
  David ElliottSep 9, 2025
  If you're hearing noise from the transformer or case of your SUNGOLD POWER Inverter, it could be due to specific loads being applied, such as a hair dryer. Try removing these loads to see if the noise stops.