User Manual 10 Operation of LCD Display Panel
83
“IT” Stage Ⅰ Protective Parameter
If the selected protective parameter is “Pro-stageⅠ”,
the following sub-menu will come up.
Press j to select parameter, Press h to move cursor
right and Press j to set the appropriate value.
Confirm settings by Pressing ENTER.
Tab. 10-12 Stage Ⅰ Protective Parameter Explanation
Parameter Explanation Parameter Explanation
Max-V.grid Grid over-voltage value Max-Fgrid Grid over frequency value
Min-V.grid Grid under-voltage value Min-F.grid Grid under frequency value
“IT” Stage
Ⅱ
Protective Parameter
The button functions for Italy Stage Ⅱ parameter setting sub-menus may
differ from that in other menus.
Proceed as follows to perform the parameter settings.
Select“Pro-stage Ⅱ”and Press j to
enter into the sub-menus.
Press j to navigate the cursor; Press h
to enter into the editing mode, then the
selected parameter will be shaded.
Press j to increase one-step value;
Press h to decrease one-step value.
Press ENTER to confirm the setting and
exit from the editing mode.
To Next Page
Loading...
Need help?
General