sunjoe TJ602E - User Manual

To Next Page

, LLC

SAVE THESE INSTRUCTIONS

A Division of Snow Joe

, LLC

OPERATOR’S MANUAL

Model TJ602E Form No. SJ-TJ602E-880E-MR6

ELECTRIC TILLER + CULTIVATOR

12-INCH | 8-AMP

IMPORTANT!

Safety Instructions

All Operators Must Read These

Instructions Before Use

Always follow these safety guidelines. Failure to do so may

result in serious bodily injury or death.

General Safety WARNINGS!

You and any other operator of this garden tiller + cultivator

must read, understand, and follow these instructions in their

entirety. Failure to follow these instructions may result in

ELECTRIC SHOCK, FIRE, and/or serious PERSONAL INJURY.

Notice the personal safety alert symbol

m used in this

manual to draw your attention to a WARNING given along

with the particular operating instruction. This means that

the operation requires special ATTENTION, CAUTION, and

AWARENESS.

1. Keep work area clean and well-lit – Cluttered, dark

areas invite accidents.

2. Replacement parts – When servicing this unit, use only

identical replacement parts. Replace or repair damaged

cords immediately.

3. Keep children, bystanders, and pets away – All

spectators, including pets, should be kept a safe distance

away from the work area.

4. Know your product – Know how to start and stop the

machine. Be thoroughly familiar with the controls.

5. Use the right tool – Do not use this machine for any job

except that for which it was intended.

6. Dress properly – Do not wear loose clothing or jewelry as

such articles can become caught in moving parts. Wear

a protective covering to contain long hair. Wearing rubber

gloves and substantial non-slip footwear is recommended

when working outdoors.

7. Extension cords – To prevent electric shock, use only

with an extension cord suitable for outdoor use.

8. Avoid accidental starting – Do not carry the garden tiller

+ cultivator with your nger on the switch. Make sure the

switch is o before plugging in or unplugging the unit.

mCAUTION! Moving parts will continue to run for several

seconds after turning o the machine.

9. Do not abuse the cord – Never carry the garden tiller +

cultivator by the cord or yank the cord to disconnect it

from the receptacle. Keep the cord away from heat, oil,

and sharp edges.

10. Moving parts – Keep hands and feet away from moving

parts. Keep guards in place and in proper working order.

11. Do not force the tool – It will perform better with less

likelihood of personal or mechanical injury if it is used at

the rate for which it was designed.

12. Do not overreach – Keep proper footing and balance at

all times.

If the tiller + cultivator strikes a foreign object, follow these

steps:

• Stop the electric tiller + cultivator.

• Inspect for damage.

• Repair any damage before restarting and

operating the tool.

13. Use safety glasses – Also use safety footwear, snug-

tting clothing, protective gloves, hearing, and head

protection.

14. Disconnect the tool – Disconnect the tiller + cultivator

from the power supply when it is not in use, before

servicing it, when changing accessories, and when

performing any other maintenance task.

15. Store idle tool indoors – When not in use, the tiller +

cultivator should be stored indoors in a dry and high or

locked-up place out of the reach of children.

16. Maintain the tiller + cultivator with care – Keep the

cutting edges sharp and clean for optimal performance

and to reduce the risk of injury. Inspect the extension

cord periodically and immediately replace it if damaged.

Keep the handles dry, clean, and free from oil and grease.

Follow the additional recommendations described in the

maintenance section of this manual.

17. Avoid dangerous environments – Do not use the tiller

+ cultivator in rain or in damp or wet locations. Do not

operate the tiller + cultivator in gaseous or explosive

atmospheres or use the tiller + cultivator near ammable

or combustible liquids. Motors in these tools normally

spark, and the sparks might ignite fumes.

18. Stay alert – Watch what you are doing. Use common

sense. Do not operate the tiller + cultivator when you are

tired or under the inuence of drugs, alcohol, or other

medication.

Need help?

Do you have a question about the sunjoe TJ602E and is the answer not in the manual?

Summary

Important Safety Instructions

General Safety Warnings

General safety guidelines for operators, emphasizing potential risks like electric shock and personal injury from incorrect use.

Operation

Safety Precautions During Operation

Emphasizes safe operating practices, including keeping area clear, avoiding wet conditions, and proper handling.

Maintenance and Storage

Electrical Safety

Details essential electrical safety measures, including GFCI protection and using appropriate outdoor extension cords.

Summary

Important Safety Instructions

General Safety Warnings

General safety guidelines for operators, emphasizing potential risks like electric shock and personal injury from incorrect use.

Operation

Safety Precautions During Operation

Emphasizes safe operating practices, including keeping area clear, avoiding wet conditions, and proper handling.

Maintenance and Storage

Electrical Safety

Details essential electrical safety measures, including GFCI protection and using appropriate outdoor extension cords.

This document describes the Sun Joe TJ602E Electric Tiller + Cultivator, a double-insulated appliance designed for small gardens and flower beds.

Function Description:

The Sun Joe TJ602E is an electric tiller and cultivator primarily used for loosening and turning over new soil. It can also be used to mix coarse soil with fertilizer, peat, and compost. The device is intended for private domestic use only and is not suitable for commercial trade use. It should not be used to till extremely dry or wet soil, nor in rain or wet conditions. The tiller operates by means of four steel blades that rotate to break up and aerate the soil.

Important Technical Specifications:

Model: TJ602E
Rated Voltage: 120V ~ 60 Hz
Motor: 8A
No Load Speed: 300 ± 10% rpm
Rotor: 4 steel tilling blades
Cultivating Width Max.: 12 in. (30.5 cm)
Cultivating Depth Max.: 8 in. (20.3 cm)
Net Weight: 23.15 lbs (10.5 kg)
Handle: Foldable (3 sections)
Input Power Consumption: 960 Watts

Usage Features:

The tiller + cultivator is designed for ease of use with several features:

Handle Assembly: The handle is foldable in three sections (upper, middle, lower) and connects using knobs, spacers, and bolts, ensuring a secure fit. A cable clip helps manage the appliance cord.
Extension Cord Management: A short power cord is provided, requiring an outdoor-suitable extension cord (e.g., SW-A, SOW-A, STW-A, STOW-A, SJW-A, SJOW-A, SJTW-A, or SJTOW-A). A polarized plug and receptacle are used to reduce electric shock risk. An onboard extension cord restraint holder and knotting method prevent accidental disconnection during operation.
Powering ON/OFF: The tool is turned ON by pressing and holding a safety lock button while pulling the ON/OFF trigger. Releasing the trigger turns the tool OFF. Users are warned that blades continue to rotate for several seconds after shutdown.
Wheel Adjustment: The wheels can be adjusted to three different positions (transport, low work, high work) to control the cultivating depth. Users must ensure both wheels are set to the same height and securely locked before operation.
Tilling Technique: For optimal results, users are advised to till in slightly overlapping rows, starting with vertical lines and then working horizontally. Light pressure on the handles is recommended for guidance, and the wheels can be used as a guide when changing direction.
Safety Features: The device is double-insulated, eliminating the need for a separate grounding system. It includes a safety lock button to prevent accidental starting. Users are advised to wear safety glasses, footwear, snug-fitting clothing, protective gloves, hearing, and head protection. GFCI protection on the circuit or outlet is recommended.

Maintenance Features:

Regular maintenance is crucial for optimal performance and safety:

General Cleaning: After each use, the product should be cleaned with a dry cloth and a brush, especially the air vents, to prevent overheating and damage. Stubborn dirt can be removed with high-pressure air. Chemical, alkaline, abrasive, or aggressive detergents should not be used.
Underbody + Working Tool Cleaning: The underbody and blades should be kept clean and free of debris. Protective gloves and appropriate tools (e.g., a wooden stick) should be used for cleaning the working tool, never bare hands. Biodegradable oil can be sprayed or rubbed onto the blades after each use.
Part Inspection: All nuts and bolts, safety devices, and cutting edges should be checked periodically for tightness, proper operation, and sharpness. Worn or damaged parts, including the extension cord, should be replaced immediately with identical OEM parts by a qualified technician or authorized service center.
Blade Replacement: The machine is fitted with four tilling blades that can be changed in pairs. Users must ensure the new blades are placed in the correct turning direction, matching how the old blades were removed, to avoid imbalance and damage.
Storage: The tiller + cultivator should be stored indoors in a dry, frost-free, well-ventilated place, inaccessible to children. The ideal storage temperature is between 50°F (10°C) and 86°F (30°C). The original packaging or a suitable cloth is recommended for protection against dust.
Transportation: When transporting, the product should be switched off, disconnected from power, and the wheels set to the transport position. It should be carried by its transport handle and properly braced if transported in a vehicle to prevent movement.

Safety Warnings:

The manual emphasizes numerous safety warnings, including:

Always read and understand all instructions before use.
Keep work areas clean and well-lit.
Keep children, bystanders, and pets away (at least 25 feet during operation).
Wear appropriate personal protective equipment.
Avoid loose clothing or jewelry that could get caught in moving parts.
Use only outdoor-suitable extension cords of proper gauge.
Do not abuse the cord; keep it away from heat, oil, and sharp edges.
Keep hands and feet away from moving parts.
Do not force the tool or overreach.
Stop the tool immediately if it strikes a foreign object, inspect for damage, and repair before restarting.
Disconnect the tool from power before servicing, changing accessories, or maintenance.
Store idle tools indoors, out of reach of children.
Maintain the tool with care, keeping cutting edges sharp and clean.
Avoid dangerous environments (rain, damp/wet locations, gaseous/explosive atmospheres).
Stay alert and do not operate under the influence of drugs, alcohol, or medication.
Check for damaged parts before each use and contact customer service for repairs.
Be aware of chemicals (fertilizers, insecticides, herbicides, pesticides, arsenic, chromium from treated lumber) that may be present in dust and debris, and work in well-ventilated areas with dust masks.
Do not operate the machine while under the influence of alcohol or drugs.
Ensure all safety devices are in place and functioning.
Hold the tiller with both hands and maintain dry grips.
Walk, do not run, and maintain proper footing, especially on slopes.
Do not overload machine capacity by tilling too deeply.
Stop the machine and disconnect power if it vibrates abnormally.
Allow blades to stop completely before transporting.
Do not grasp exposed cutting blades or edges.
Allow the motor housing to cool completely before touching or storing near combustible material.
Wear protective gloves when cleaning or maintaining the machine.
Do not use cleaning fluids, solvents, or spray water directly on the machine.