sunjoe TRJ608E - Troubleshooting

13
Troubleshooting
Most diculties are easy to x. Consult the troubleshooting table for common problems and their solutions. If you continue
to experience problems or need repairs beyond these minor adjustments, please call 1-866-SNOWJOE (1-866-766-9563) for
assistance.
Problems Possible Cause Possible Solution
The motor does not
run or the tool runs
slowly
• Power failure/unit not plugged
into a working receptacle.
• Spool housing cannot rotate freely.
• Trimming line does not protrude.
• Check to make sure the unit is plugged into a working
outlet. Make sure the extension cord is not damaged.
• Remove the spool and clean the slots; carefully remove
any grass and weeds or other debris.
• Cut the spool line o so that it just reaches the line
trimming blade.
• Take the trimmer to an authorized service center if the
trimmer does not start after completing these checks.
• Stop the machine and clean the line trimming blade.
• Install a new spool of cutting line.
• Remove the spool cover and pull the trimming line until it
reaches the line trimming blade.
• Line trimming blade bound with
accumulated grass.
• The spool runs out of line.
• Spool bound up.
• Spool line twisted when relled.
• Not enough line is exposed.
Semi-auto line
feeding system does
not work
• Contact your authorized Snow Joe
®
+ Sun Joe
®
dealer
or call Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563).
• Rewind or trim line to the line trimming blade
• Line trimming blade in guard is
covered, damaged, or missing.
• Line extends past guard.
Line fails to cut o