12
Assembly (continued)
10
9
Unscrew the four screws that are preassembled on the
head assembly (C). Place the head assembly (C) into the top
of the post (D) by inserting the regulator (H) into the post
(D). Tightly fasten the previously removed screws back into
the head assembly (C) through the slots at the top of the
post (D).
Remove the preassembled screws from the post support
(F) and attach the post (D) to the post support (F) using those
four screws.
Attach head assembly to post
Attach post to the post support
To Next Page
Loading...
