Attach the feet pegs with supplied Allen wrench
and bolts to the underside of floor .
NOTE: Make sure the floor panel is on a surface that
is perfectly level and relatively smooth.
2 E
A
Unpack each wall segment from the shipping material. Stage each
wall segment in the room you will be assembling the unit.
STEP 1
Place the back wall on the back of the floor panel .
Be sure you have two people assisting with this step.
This is the side with the sauna information label
on the bottom edge.
STEP 2
PRE-STEPS
A
2
12
1
F E
230V, 21000 watts.
3m cord exits from back left of roof.
See USER MANUAL or spec sheet for
additional specs.
E
E
E
F
2
sunlighten.com/gb-en
To Next Page
Loading...
