•
Attach the feet pegs with supplied Allen
wrench and bolts to the underside of floor
(see illustration 1.1).
•
Cut the zip ties holding the floor grate,
the fabric will adhere to the Velcro on the
underside of the grate (see illustration 1.2).
TIP: One side of the fabric adheres better
NOTE: Make sure the floor panel is on a surface
that is perfectly level & relatively smooth.
2 E
A
•
Un-pack each wall segment from the shipping material.
•
Stage each wall segment in the room you will be assembling the unit.
*
Failure to do so will void your sauna's warranty
and customer will assume liability for any electrical
damages to the sauna itself or the residence/business
in which the sauna is installed.
240V, 1673 watts. Dedicated 10A circuit and
10A power socket protected by a 10A RCBO
installed in the meter box.
Minimum 1.5mm cable required for circuit;
2.5m cord exists from back left of roof.
*
See USER MANUAL
STEP 1
STEP 2
PRE-STEPS
A
2
4
1.1
1.2
•
Place the back wall on the back of the floor panel .
•
Be sure you have two people assisting with this step.
This is the side with the sauna information label
on the bottom edge.
H
E
E
E
E
H
2
sunlighten.com.au
2
sunlighten.com.au
To Next Page
Loading...
Need help?
General
