To Next PageTo Next PageWhy does my Sunny Health & Fitness Fitness Equipment make a squeaking noise?
If your Sunny Health & Fitness Fitness Equipment is making a squeaking noise, it might be due to loose bolts. Inspect all bolts and tighten any that have become loose.
What to do if there is no display on the Sunny Health & Fitness Fitness Equipment computer?
If there is no display on the computer of your Sunny Health & Fitness Fitness Equipment, here are a few things you can try: 1. Ensure the wire from the computer is properly connected to the wire from the handlebar post. 2. Verify the batteries are correctly positioned and the battery springs are making proper contact. 3. Replace the batteries with new ones, as the current batteries may be unresponsive.
How to stop Sunny Health & Fitness Fitness Equipment from wobbling?
To stop your Sunny Health & Fitness Fitness Equipment from wobbling, turn the rear end caps on the rear stabilizer as needed to level the bike.
What to do if there is no display on my Sunny Health & Fitness Exercise Bike computer?
If the Sunny Health & Fitness Exercise Bike computer display is blank, first, ensure the computer wire is properly connected to the handlebar post wire. Then, check that the batteries are correctly positioned and making contact with the battery springs. If the display remains blank, replace the batteries with new ones.
General| Type | Elliptical |
|---|---|
| Weight Capacity | 300 lbs |
| Display | LCD |
| Resistance Type | Magnetic |
| Drive System | Belt drive |
| Transport Wheels | Yes |
| Heart Rate Monitoring | Pulse Sensors |
| Display Functions | Time, Speed, Distance, Calories, Pulse |
| Resistance Levels | 8 Levels |
| Seat Adjustment | No |
Attach Front & Rear Stabilizers to Main Frame using bolts, washers, and cap nuts.
Connect tension control wire and attach handlebar post to the main frame.
Attach swing rods to handlebar post and connecting rods to cranks.
Attach pedals and pedal plates to connecting rods using bolts, washers, and nuts.
Attach small handlebar to handlebar post and computer to handlebar post.
Attach left and right handlebars to swing rods using bolts, washers, and cap nuts.
Attach seat slide onto seat post and adjust position.
