Need help?Do you have a question about the Sunpak S34 and is the answer not in the manual?
Steps to take if you smell gas, including ventilation and contacting services.
Precautions against storing flammable vapors near the appliance.
Hazards related to improper installation, adjustment, or service.
Examine heater installation for obstructions, support, and deterioration before use.
Instructions for starting and safely shutting down the heater.
Guidance on annual service for optimal heater performance.
Recommendations for cleaning and maintaining the stainless steel casing.
Ensuring proper ventilation and clearances during building alterations.
Critical placement for effective and efficient patio heating.
Impact of wind, air pressure, and ventilation on heater performance.
Critical safety alerts regarding carbon monoxide and fire hazards.
Strategies for effective temperature management using thermostats.
Mandatory clearances from combustible materials for safe installation.
Maximum allowable tip angle and its effect on clearances.
Adherence to local codes for overhead heater placement.
Optimizing heater placement to offset heat loss effectively.
Grouping heaters with a 30-degree angle facing away from each other.
Evenly distributing heaters along the roof without angling.
Angling heaters at 30 degrees to face towards each other.
Procedures for inspecting received equipment for external damage.
Emphasis on qualified personnel for installation and service.
Adherence to national and local codes for installation.
Required gas inlet and manifold pressures for natural gas and propane.
Minimum clearances to combustible materials and adjacent structures.
Information regarding the optional mounting kit and its clearances.
Visual representation of minimum clearances using the optional mounting kit.
Diagram showing heater dimensions and gas/electrical connection points.
Guidelines for installing heaters near fire sprinkler systems.
Requirements for 24 VAC transformer, wire gauge, and replacement wiring.
Ensuring secure, noncombustible mounting and vibration isolation.
Warning about disconnecting power and gas before servicing.
Ensuring proper venting for combustion air and gas removal.
Guidelines for gas pipe sizing, shut-off valves, and leak detection.
Step-by-step guide for initial heater power-up and gas ignition.
Schematic for connecting heaters to low voltage transformer and switches.
Procedures for safely servicing the heater, including burner removal.
Diagnosing and resolving problems like no spark or burner not lighting.
Wiring diagram and operational sequence for the RAM-3 ignition module.
Wiring diagram and operational sequence for the Synetek ignition module.
Detailed steps for disassembling the heater to replace the burner.
Ensuring proper combustion gas exit for angle-mounted heaters.
Proper installation for horizontal mounting, allowing uniform air pressure.
How improper mounting can lead to heater damage and deterioration.
List of all component part numbers and descriptions for the heater.
List of part numbers and descriptions for the optional mounting kit.
Common causes for the pilot not igniting or producing a spark.
Potential reasons why the main burner fails to ignite.
Factors causing unpredictable or erratic heater performance.
Causes and corrections for damage to the heater's front grill.
Symptoms and resolution for burner noise, indicating potential damage.
Details of the limited warranty for original owners and component parts.
Owner's responsibility for costs beyond replacement parts or heaters.
Restrictions on implied warranties like merchantability duration.
Steps to initiate a warranty claim by contacting the dealer or manufacturer.
To Next Page
General