Sunpak S34?TSR - User Manual

Questions and Answers

R
Richard BishopJul 26, 2025
What to do if my Sunpak S34?TSR Patio Heater burner won’t light?
- J
  juliecrosbyJul 26, 2025
  If your Sunpak Patio Heater burner won’t light, there might be several reasons: * There may be air in the gas line. * The gas pressure might be low. * The gas valve could be bad. * The manual gas valve may be turned “OFF”. In this case, turn the valve handle to the full “ON” position. * The manual gas valve may not be fully “ON”. Turn the valve handle to the full “ON” position. * The burner orifice may be plugged. To resolve this, remove the heater top, then remove the burner orifice (using a ½” hex wrench) and clean it thoroughly.
L
Laura PachecoJul 30, 2025
Why does my Sunpak S34?TSR Patio Heater have inconsistent operation?
- D
  Derek RobertsonJul 30, 2025
  Inconsistent operation of your Sunpak Patio Heater can be due to: * Variable gas pressure. * Variable voltage. * Wind exceeding 10 mph. * Tip angle exceeding 30 degrees. * Debris inside the burner. * Erratic winds.
M
Micheal JonesAug 3, 2025
What does it mean when my Sunpak S34?TSR Patio Heater module has four beeps every two seconds?
- E
  Eric JohnsonAug 3, 2025
  Four beeps every two seconds indicates that the module’s internal temperature has exceeded 170° F (77° C). Allow the module’s internal temperature to cool to below 160° F (71° C), and then press the ON button.
T
Tracey FisherAug 8, 2025
What does it mean when my Sunpak S34?TSR has one beep every four seconds?
- J
  Jennifer TranAug 8, 2025
  One beep every four seconds indicates that the flame safety circuit has locked out. To resolve this, press the OFF button to reset, then press ON to restart the Sunpak Patio Heater.
I
Isabella RobbinsAug 12, 2025
What does it mean when my Sunpak Patio Heater module has four “beeps” every one second?
- C
  Christopher WilsonAug 12, 2025
  Four beeps every one second warns that the pilot flame sensor detects a pilot flame already present when the ignition sequence is initiated, or the pilot flame sensor on the main control module is shorted to ground. To fix this, adjust the sensor electrode to 3/16” for the pilot hood and 3/8” from the spark electrode, ensuring the electrode is within the flame zone.
A
alexanderhamiltonAug 17, 2025
Why is the front grill of my Sunpak S34?TSR Patio Heater deteriorating?
- B
  Brandy MorrisAug 17, 2025
  The Sunpak heater must be installed in such a manner as to allow the products of combustion or hot gases to vent out the top of the heater. When operating normally, only radiant heat passes through the front grill. If conditions exist which force hot gases through the front grill of the heater, the installation must be altered to correct the condition.
M
mtaylorAug 21, 2025
Why is my Sunpak S34?TSR making a rumbling burner noise?
- T
  Tina PatrickAug 21, 2025
  These symptoms may occur any time after the Sunpak Patio Heater has warmed up. Under these conditions the burner has been damaged and must be replaced. Discontinue use of the heater until heater is repaired.