SunPower Maxeon - Page 14

MAXEON SOLAR TECHNOLOGIES, LTD.
537620 Rev.I
©2024 Maxeon Solar Technologies, Ltd. All rights reserved. Specifications included in this document are subject to change without notice. 13
2 Test loads are for informaon purposes only, design loads should be considered for the project design.
 Design Load considers 1.5 Factor of Safety, Test load = Design load x 1.5. Product Warranty covers only design
load values. The design loads listed in this table supersede all other loads that may be defined by other
pares, unless there is a formal authorizaon by Maxeon.
Mounng
Configuraon
Descripon
Mounng Configuraon Diagram
Front View
Back View
Mounng Zone
Locaons
(distance from corner
in mm)
50 - 180
Long Side Mounng,
Rails Perpedincular to
Mounng Frame
Long Side Mounng,
Rails Parallel to
Mounng Frame
Short Side Mounng,
Rails Parallel to
Mounng Frame
(End Mount)
180 - 472
+3600/-2400
+5400/-2400
+2400/-2400
+2400/-1600
+3600/-1600
+1600/-1600
TOP CLAMPS
GEN 4.3 FRAME PROFILE
A - Ground Holes (4X Ø 4.2mm)
B - Mounng Holes (8X Ø 6.8mm)
SunPower Performance 3 Residenal AC Solar Panel
(SPR-P3-XXX-BLK-E3-AC, SPR-P3-XXX-BLK-E4-AC)
1086 mm
1690 mm
0
SIDE FRAME PROFILE
END FRAME PROFILE
0
350
1100 mm
Corner Mounng,
Long Side
Test Load
Downward/Upward
(Pa)
Design Load
Downward/Upward
(Pa)

3 Rails must not be under the Microinverter.
1038 mm
4 In the cases where hybrid mounng is necessary (combinaon of long and short side mounng), the lowest
design load values should be considered as allowable design load.

0 - 240
+1400/-1400
+933/-933
372 - 472
350
50 - 372 +3600/-1800
+2400/-1200

5 Boom flange mounng
Measurement Tolerances are +/-3mm for the Length and Width of the module.

6 Range indicates posioning of the clamp and not the rails
0 - 50
+2400/-1600 +1600/-1067
(End Mount)
1300 mm
1500 mm
MICROINVERTER
EXCLUSION ZONES
Short Side Mounng,
Rails Perpedincular to
Mounng Frame
240 - 340
+6000/-2400
+4000/-1600
565 mm
355 mm
B A
35 mm
35 mm
32 mm 24 mm
472 - 690
+2400/-2400 +1600/-1600
240 - 340
+2400/-2000 +1600/-1333
80 - 180
+6000/-2400
+4000/-1600
472
180
0
0
50
690
472 180
50
690