SunStar 27N - Engine Access - Interior

SECTION 3 -
DRIVING YOUR MOTORHOME
3-14
To Close Hood
• Swing hood panel up into closed position.
• Press top edge of hood panel in with palms of
hands, while locking Hood Locks.
ENGINE ACCESS – INTERIOR
Front Engine Cover
(Located between cab seats)
NOTE: Take precautions to protect carpet and
interior furnishings when removing
engine cover. The underside of the engine
cover could contain deposits of oil and
fuel or other engine fluids and
substances that could damage fabrics
and interior furnishings.
• To remove the engine cover, insert the
supplied hex wrench into the hole (located on
the top center or the front edge of the engine
cover, depending on model).
• Turn the hex wrench to the left (counter-
clockwise) to unlock.
NOTE: On certain models, there may also be
additional screws to remove at the lower
front corners on each side of the engine
cover. See following photo.
• Remove engine cover and set aside.
• Insert hex wrench into the hole located on the
top center of the engine cover (as shown) or
the front edge of engine cover (depending on
model) to unlock.
-Typical installation shown
• Remove screws at the lower front corners on
each side of the engine cover (if equipped).
-Typical installation shown
-Typical View