12
[Figure 7]
[Figure 8]
6) Installation of belt cover
Fix the belt cover “A”① to the machine’s body using 3 fixing screws②.
You can assemble it more easily if you slightly incline the machine.
When the assembly of the belt cover “A”is finished, insert the front side of the belt cover “C”③ into the groove of belt
cover “A”① and fix the back side with the fixing screw④.
Attach the belt cover “B”④ to the table.
Please make sure that the belt do not intervene with the inside of the belt cover “B”④.
7) Installation of synchronizer
(for automatic trimming type)
Installing on the servo motor
In case of installing the servo motor (in-built synchronizer), a
synchronizer sensor is attached to the backside of the arm.
The appropriate clearance between the synchronizer and the
pulley is 1.2mm.
[Figure 9]
[Figure 6]
5) Installation of program unit
(for automatic trimming type)
Fix the bracket② onto the program unit①, using 4
fixing nuts③.
Then, use 2 fixing bolts④ to tightly fix the bracket②,
where the program unit ① has been adjusted, along with
the back cover.
To Next Page
Loading...
