SunSun CSP-250 User Manual

© by WilTec Wildanger Technik GmbH Item 52371 Page 7
http://www.WilTec.de
http://www.aoyue.eu 06 2021-1
http://www.teichtip.de
Operation modes
1. “Fountain” mode is activated with the fountain unit (1–4) being installed and the reversing
valve (12) being in “fountain” position.
2. “Skimmer” mode is activated with the filter basket handle (6) being installed and the reversing
valve (12) being in “skimmer” position.
Cleaning and maintenance
1. Regularly clean the filter basket to avoid that too much waste affects the skimmer efficiency.
2. Regularly clean the filter sponge in the water. Do not shake it vigorously and do not use any
chemical cleaning products.
3. With less water than normally entering the device, disassemble it by removing the rear cover.
Remove all mud and other obstructing material accumulated on the rotor unit.
4. If the device is visibly cracked or worn, repair or replace it in time to ensure your own safety and
normal operation. If maintenance work risks take a lot of time or if several parts must be re-
placed, contact a qualified person.
Winter storage
• Take out the device of the water.
• Thoroughly clean the device.
• Check the device and/or power cable for damages.
• The device must be stored in a frost-free place and in a container with as much water as possi-
ble.
Note: Never immerge the power plug into the water!
Trouble shooting
Problem
Cause
Solution
Device not operable
Lack of power
Check power source or socket.
Defective pump
Check pump.
Water outlet decreases
Fountain head too loose
Adjust fountain head.
Sponge too dirty
Clean sponge.
Pipes clogged
Clean pipes.
“Skimmer” mode affected
Too low water level
Water level must not fall below
35 cm.
Filter basket overfilled
Empty filter basket.

SunSun CSP-250 Specifications

General

Brand	SunSun
Model	CSP-250
Category	Pond Pumps
Language	English