Why is the water outlet decreasing in my SunSun Pond Pump?
A decrease in the water outlet of your SunSun Pond Pump can occur due to several reasons. The fountain head might be too loose, requiring adjustment. The sponge could be too dirty and needs cleaning. Alternatively, the pipes might be clogged, so ensure you clean them.
What to do if my SunSun Pond Pump is not working?
If your SunSun Pond Pump is not working, start by checking the power source or socket to ensure there is no lack of power. If the power source is working, then check the pump for any defects.
Why is the skimmer mode not working on my SunSun Pond Pumps?
If the skimmer mode on your SunSun Pond Pumps is not working, it could be due to a couple of reasons. The water level might be too low; ensure it does not fall below 35 cm. Another possible cause is an overfilled filter basket, so you should empty it.
Specifies the suitable operating temperature and minimum water level for the product.
Lists essential safety precautions for operating the pond skimmer, including electrical safety and usage.
Details the dual operation modes (skimmer/fountain) and key design elements of the device.
Outlines procedures for regular cleaning, maintenance, and care of the pond skimmer.
Provides instructions for proper storage of the device during winter to prevent damage.
Lists common issues, their causes, and recommended solutions for the pond skimmer.
General| Power | 250W |
|---|---|
| Max Flow Rate | 12000 l/h |
| Max Head | 6.0m |
| Voltage | 220-240V |
| Frequency | 50Hz |
| Power Consumption | 250W |
| Cable Length | 10m |
To Next Page
