© by WilTec Wildanger Technik GmbH Item 52371 Page 4
http://www.WilTec.de
http://www.aoyue.eu 06 2021-1
http://www.teichtip.de
Installing the product
• Before installing, carefully read the safety instructions.
• Connect all parts of the product and check them for defects or lacks.
• Attach a cord to the bottom part of the product.
• Put the product into the water and fill it with the water.
• Find a suitable location and adapt the cord length.
• Attach the other end of the rope to one of the fixing bars.
• Firmly position the fixing bar into the muddy zone outside the pond so that the device cannot
leave its operation zone with the driving-away water.
• Connect the device to the mains and put it into operation.
Features
1. The device has two main features: The operation modes “skimmer” and “fountain” can be acti-
vated by turning the reversing valve. With the reversing valve being in the “skimmer” position,
the device operates as a skimmer (see Fig. 1), with the reversing valve being in the “fountain”
position, the device operates as a fountain (see Fig. 2).
2. With the installed water pump operating, the water level forms a high-low difference. Most sus-
pended particles as branches and leaves are collected inside the filter basket, small contami-
nants are absorbed by the filter sponge, and the filtered water flows back into the pond.
3. The floating elements make for the device floating on top of the water and it staying at its oper-
ating position so that it does not sink to the ground.
4. Installed filter basket construction, large skimming capacity, long maintenance period
5. Equipped with accessories for fountain operation. The device not being used as fountain, the
fountain accessories must not be installed.
To Next Page
Loading...
Need help?
General
