What to do if lamps fail to light on Sunvision Scientific PRO 24S?
If your Sunvision Scientific Grill's lamps fail to light, here are a few things you can try: 1. Verify the AC power source. If needed, reset the circuit breaker or replace the fuse. 2. Ensure the unit is properly plugged into the outlet. 3. Check that the cord connecting the canopy and bench is securely connected. 4. Confirm that the timer dial is set to a value greater than 0.
Why my Sunvision Scientific PRO 24S does not stay lit?
If your Sunvision Scientific Grill does not stay lit, here are a few things you can try: 1. Check the AC power source and reset the circuit breaker or replace the fuse if necessary. 2. Check timer system per maintenance instructions in this guide. Contact your local service representative.
What to do if one or more lamps fail to light on Sunvision Scientific PRO 24S?
If one or more lamps on your Sunvision Scientific Grill fail to light, follow these steps: 1. Ensure the lamp is correctly installed. 2. Swap the non-lighting lamp with one that is working. If the new lamp lights up and the old one still doesn't, replace the old lamp. 3. If replacing the lamp doesn't solve the issue, contact your service representative.
How to fix Sunvision Scientific PRO 24S canopy that fails to stay in position?
If the canopy of your Sunvision Scientific Grill fails to stay in the up or down position, replace the gas springs when they no longer have sufficient power to aid in lifting the canopy.
Warns about UV risks, overexposure, and protective eyewear.
Provides a table of exposure times based on skin type and session number.
Solutions for when the tanning lamps do not illuminate.
Troubleshooting steps for partial lamp failure.
How to fix issues with the canopy not holding its position.
Solutions for the sunbed turning off unexpectedly.
General| Brand | Sunvision Scientific |
|---|---|
| Model | PRO 24S |
| Category | Grill |
| Language | English |
To Next Page
