Tyco Solarlok connector
The Tyco Solarlok connectors are only
approved for connection to permanently
laid cables!
They must not be disconnected under
load!
The circuit must be interrupted at a sui-
table point! The cables must be provided
with a suitable adhesive label close to
the Tyco Solarlok connector!
The Tyco Solarlok connectors must
always be disconnected from other vol-
tage sources on all sides during assem-
bly, in order to protect against electric
shock.
!
(Fig.) Manual crimping tool for assembly of
Tyco Solarlok connectors
(Fig.) Tyco Solarlok connectors
164
To Next Page
Loading...
