• Enter [installer code] [7] [Address of the user code] (User code addresses start at 000 for code 0, 004
for code 1, 008 for code 2, etc)
• If a code is already stored in that address it will be shown one digit at a time. The keypad will give a
beep.
• Enter [#] [6] in place of the first digit, or press [∗] to enter a new address.
• Press [∗] to exit programming.
19. How To Overwrite User Codes
• User codes are added through programming. User code 0 is the master code, and user code 1 is the
installer code. User codes 2 through 7 have full access, and user codes 8 through 15 are arm/ disarm
only.
• Enter [installer code] [7] [Address of the user code] (User code addresses start at 000 for code 0, 004
for code 1, 008 for code 2, etc)
• If a code is already stored in that address it will be shown one digit at a time. The keypad will give a
beep.
• Enter the new code over the top of the old one, or press [∗] to enter a new address.
• Press [∗] to exit programming.
To Previous Page
Loading...