SUPAIR EVO Lite - Installing the Speed-Bar System; Speed-Bar System Lines; Speed-Bar System Crimped Hooks; Elasticated Speed-System Installation

User’s manual | EVO Lite
SUPAIR | EVO Lite | page 12
Push the accelerator cord through the lat-
eral skirt slot.
Installing the speed-bar system.
The EVO Lite is pre-equipped to use a speed-bar as most of our harness models are.
Within the SUP’AIR gear lineup, the standard speed-bar is the most adaptable for being the
lightest and self-retractable.
4
3
2
1
Push the accelerator cord through the
guiding tube.
Push the speed-bar line through the pul-
ley.
Attach the end of the speed-bar lines to
the crimped hooks which is to be connect-
ed to the riser’s crimped hooks. Adjust the
lines length and securely knot it.
A
Lines
B
C
Crimped hooks
Elasticated self-retractable speed-system
Self-retracting speed-system: push the
elastic cords through the (D) ring to con-
nect them to the white loop stitched on the
inner sides of the harness.
5
A
C
If the foot rest is not used, the lateral skirt
can be folded over and around the guiding
tube and close by pressing the button.
6
E
1
3
4
5
2
D
F
D
E
(D) shaped buckle.
Elasticated
recoil cord.
Elasticated recoil cord.
Speed-bar cord.
F
5