9
MODE or HOLD keys to select T1 or T2.
When data is full (5 sets), the OU icon will be displayed.
To clear memory, press the MEM key for more than 2
seconds. the CLER icon will be displayed.
Press LIMIT To enable the Hi/Lo alarm function.
Press SHIFT then press the LIMIT key to turn the
Hi/Lo alarm ON or OFF.
4. key
When pressed, a icon will be displayed and the
measurement is held. Press the key again to cancel
the hold function.
Press the key for more than 2seconds and the back
light will be turned on. The icon will be displayed.
Press the key again for more than 2 seconds and the
backlight will be turned off. (The icon will disappear.)
HOLD
Light
To Next Page
Loading...